Washers without chamfer DIN 125-1-A-steel 140 HV coated zinc flake 6,4 mm

The combination of strength classes for flat washers with those for bolts and nuts is governed by ISO 898-3:2018, Table 1. Washers with a hardness of 140 HV are suitable for applications with unhardened bolts up to strength class 5.8 and nuts up to class 5. Applications involving bolts of strength class 6.8 and nuts of class 6 must be checked during installation. Combinations with higher strength classes must not be used.

Steel is an iron-carbon alloy with a maximum carbon content of 2% by mass. The steels achieve their intended physical and mechanical properties through various hardening, annealing and tempering processes. It is also possible to harden the edge zone by surface hardening, case hardening or nitriding. Well-known steel grades are structural steels, free-machining steels, case-hardening steels, nitriding steels, tempering steels, tool steels and stainless steels.

Zinc flake coatings are non-electrolytically applied coatings in accordance with DIN EN ISO 10683. Additional top coats and lubricants may be applied. As this is a non-electrolytic process, no hydrogen is produced which could cause the components to become brittle. This requires correct pre-treatment. The corrosion protection is 10 times greater than that provided by electroplated coatings of the same thickness.