{{ name }}
Article no. {{ combinedCodeWithHighlight }}
Article code:
EAN / GTIN:
Manufacturer number:
Cat. No.:
Wedge anchor zinc-plated steel FBN II 8/10
Article no.: 417675
Catalog no.: 4980
Article code:
Product details
Technical Data
| d0 | 8 mm | |
| t fix | 10 mm | |
| SW | 13 mm | |
| Number of nuts | 1 | |
| Material | Galvanised steel | |
| Fixing with expansion tool | No | |
| Suitable for cracked concrete | Yes | |
| Drive | Hexagonal | |
| M | M8 | |
| hef | 40 / 30 mm | |
| t d | 66 mm | |
| Suitable for non-cracked concrete | Yes | |
| Professional / DIY | DIY | |
| With collar | No | |
| Number of washers | 1 | |
| Surface protection | Galvanic/electrolytic zinc plated | |
| T inst | 15 mm | |
| Anchoring depth | 40 mm | |
| Head marking | B | |
| Packing | Folding box | |
| l | 71 mm | |
| M x ls | M8 x 39 mm | |
| Test marks / approvals | ETA - European Technical Assessment |
Identification & Classification
| Article number | 417675 | |
| Catalog number | 4980 | |
| EAN / GTIN | 4006209406649 | |
| Manufacturer number | 40664 | |
| Article class | RMC |
Description
Advantage:
- The standard anchorage depth achieves the maximum load-bearing capacities. Thus fewer fixing points and smaller anchor plates are required.
- The reduced anchorage depth reduces the drill hole depth. This minimises the amount of time needed for installation whilst increasing flexibility.
- The long thread balances component tolerances and allows for stand-off installations, thus increasing flexibility.
- Few hammer blows and the minimal torque slippage allow for a noticeably simpler installation.
- The drive-in pin protects the thread from damage, and thus ensures a faster installation and dismantling of the attachment.
Application Area:
- Steel constructions
- Guard rails
- Consoles
- Ladders
- Machines
- Gates
- Façades
Approved for:
- Concrete C20/25 to C50/60, non-cracked
- Concrete C12/15
- Natural stone with dense structure
Application Notes:
- The FBN II is suitable for pre-positioned and push-through installation; also suitable for stand-off installation under certain conditions.
- Prior to installation, place the hexagon nut in the optimal position (the drive-in pin projects by approx. 3 mm out of the hexagon nut).
- When applying the torque, the cone bolt is pulled into the expansion clip and expands it against the drill hole wall.
- The head embossing offers a simple control of the anchoring.
- In the case of series installation, we recommend using the FABS bolt anchor setting tool.