{{ name }}
Article no. {{ combinedCodeWithHighlight }}
Article code:
EAN / GTIN:
Manufacturer number:
Cat. No.:
Revolving centering taper, truncated cone, very large ⌀ / Morse taper: 100/4
Article no.: 616675
Catalog no.: 323000
Article code:
Product details
Technical Data
| Head diameter D | 100 mm | |
| Type of centring point | tracking | |
| Point angle α | 75 degrees | |
| Largest point diameter D1 | 100 mm | |
| Bull-nosed taper at front | yes | |
| Smallest point diameter D1 min | 30 mm | |
| Head length L1 | 101 mm | |
| Mounting machine-side | MT4 | |
| With push-off thread | no | |
| With clamping faces | no | |
| With carbide tip | no | |
| With shock absorbing | no | |
| Max. workpiece weight | 650 kg | |
| Maximum speed | 3,000 min-1 | |
| Maximum radial run-out | 0.005 mm | |
| Half centring point | no | |
| Replaceable centring points included | no | |
| Use | turning | |
| Type of product | centring drill |
Identification & Classification
| Article number | 616675 | |
| Catalog number | 323000 | |
| EAN / GTIN | 4045197774750 | |
| Manufacturer number | 323000 100/4 | |
| Manufacturer/responsible person | Hoffmann Supply Chain GmbH & Co. KG, Poststraße 15, 90471 Nürnberg, Germany, www.hoffmann-group.com |
Description
Version:
- Centering taper with truncated cone.
- Particularly sturdy design with oversize bearings.
- The bearings have a special lubricant and require no maintenance.
- The centering taper and tapered arbor are made of high quality material, through hardened and finish ground.
Description:
Lathe centres are mainly used on lathes to support long and slim workpieces, since with these workpieces there would otherwise be a risk of the workpiece bending or moving around as a result of the forces generated.
The lathe centre is secured with a Morse taper. The workpiece is clamped in the chuck and a counterbore is added using a centre drill. After re-clamping, the lathe centre is then inserted.
The lathe centre is secured with a Morse taper. The workpiece is clamped in the chuck and a counterbore is added using a centre drill. After re-clamping, the lathe centre is then inserted.
Application:
For machining hollow parts, tubes etc. Particularly suitable for heavy machining where at the same time high accuracy is required.