Tool24 Smartline – upright cabinet fitted with tool sockets, for tool shanks: SK30

The pull-out shelves are supported from the base and equipped with central locking (can be used for emergency release). The end faces of the hot-dip galvanised frames of the pull-out shelves have holes at intervals of 37 mm for mounting tool carriers, support rails, shelf trays, and perforated panels. The pull-out frames are equipped with an anti-tilt device. The pull-out frames open automatically. This ensures quick access to the tools.

• Storage of pre-set tools.
• Only for use in conjunction with a Tool24 Smartline Master Unit system.
• Available with 14 different configurations (for different tool shanks SK, VDI, C, HSK).
• Supplied with 24 carrier rails.
• Mountings suitable for tool stands, support rails, shelf trays and perforated tool panels.
• Distributed safe working load per pull-out frame: 600 kg.
• Maximum upright cabinet load: 2400 kg.
• Locking system for emergency release.

Automatic industrial vending solution for storage and management of tools and C-items.

Body RAL 7035 light grey, pull-out frames RAL 7016 anthracite powder-coated.

Upright cabinets place increased demands on the floor, since the pull-out frames run directly on the floor! The following pre-requirements for the installation site must be satisfied absolutely by the customer:

• Flatness tolerance for finished floors as per DIN 18202.
• Angularity of a maximum of 2 millimetres over the measurement length of 1 metre.
• The subsurface must have a sufficient load-bearing capacity.
• Only place on ground that is absolutely level.

The systems are prepared for wall or floor-mounting and must be secured against tilting.
These upright cabinets can only be used in conjunction with a Tool24 Smartline Master Unit system No. 979001 S11M or No. 979001 S11M-EN, Tool24 PickOne Master Unit system No. 979201 DE or No. 979211 EN, and Tool24 Locker Master Unit system No. 979300 DE or No. 979310 EN.