Express anchor 10/50/125 IMC

The Upat Express Anchor IMC is the cost-effective specialist in the area of bolt anchors. This steel anchor, in a galvanised version, is particularly suitable for fastening medium to heavy loads indoors in uncracked concrete and natural stone with a dense structure. The Express Anchor IMC can be set in pre- and push-through installation and hammered into the blown-out drill hole. When the nut is tightened, the bolt pushes itself into the expansion clip, which expands against the borehole wall, thus ensuring a high level of holding security. The bolt anchor is used particularly frequently for fastening cable support systems and stair railings.

• Secure anchoring: ETA concrete approval option 7. Versatile use for secure anchoring in uncracked concrete
• Fastening close to edges: The cone and expansion clip unit enables minimal edge and centre distances
• Easy to install: Shaft with optimised diameter for low impact energy.
• Protected thread: Distinctive impact pin protects the thread from damage during the setting process
• Reliable follow-up check: The head embossing enables follow-up checks when installed
• Secure hammering: The clip remains in position during hammering, even if it hits reinforcement or unfavourable drill holes.

Material

• Stainless steel (R/A4): For fastenings outdoors or in damp rooms.
• Galvanised steel (gvz): For fastenings in dry indoor areas

Variants

• Short (K): The short version of the bolt anchor reduces the drill hole depth and the risk of hitting reinforcement, and enables quick installation while saving costs
• Large washer (GS): The large washer protects the surface of the attachment and prevents cutting into wood

Approved for:

• Concrete C20/25 to C50/60, non-cracked

Also suitable for:

• Concrete C12/15
• Natural stone with dense structure

Function: When the nut is tightened, the bolt pushes into the expansion clip, which spreads against the borehole wall.

Installation: The Upat Express anchor IMC is installed using through-hole mounting. Drill the hole, clean the hole. Drive in the bolt anchor. Tighten to the specified torque – done. The bolt diameter is equal to the hole diameter

Tools: Drill, drill press, blow-out pump (UPM AB), hammer, torque wrench