{{ name }}
Codice art. {{ combinedCodeWithHighlight }}
Codice materiale:
EAN / GTIN:
Codice del produttore:
Codice articolo:
Ancoraggio a vite TermoZ CS II 8/155 DT 110 V
Codice art.: 2242500
N. del catalogo: 5952
Codice materiale:
Dettagli prodotto
Dati tecnici
| Professionale / Fai da te | Profi | |
| Profondità di ancoraggio | 25 mm | |
| Azionamento | TX30 |
Identificazione e classificazione
| Codice articolo | 2242500 | |
| Numero del catalogo | 5952 | |
| EAN / GTIN | 4048962420388 | |
| Codice del produttore | 559412 | |
| Classe dell`articolo | RMH |
Descrizione
Vantaggi:
- Pre-assembled fixing with a 110 mm plate for countersunk mounting.
- The compound screw minimises thermal bridges, thus there are no anchor marks on the façade.
- The combination of the advantages of countersunk installation and additional plates achieves a homogeneous surface with higher pull-through values at the same time.
- The very thin plate edge provides an optimal fit to the insulation board and the application of thin reinforcement layers.
- Due to the special expansion zone of the anchor sleeve, the TermoZ CS II, is the first insulation anchor with an approval for hammer-drilled holes in vertically perforated bricks.
- The closed plate does not allow dirt to be ejected and thus ensures a clean setting result.
- The special geometry of the underside of the plate reduces the necessary insertion torque for convenient and fast installation.
Area di applicazione:
- Building material classes A, B, C, D, E
- Concrete
- Building brick
- Solid sand-lime brick
- Lightweight concrete
- Weather shell
- Vertically perforated brick
- Perforated sand-lime brick
- Hollow blocks made from lightweight concrete
- Lightweight aggregate concrete
- Aerated concrete
- Countersunk installation of soft insulation materials such as mineral wool boards on concrete and masonry
Note applicative:
- Fast countersunk installation with the TermoZ CS setting tool and a standard hammer drill or cordless screwdriver.
- The fixing is pushed through the insulation into the drill hole and is screwed in.
- The installation is completed when the plate is flush with the insulation board.
- After countersunk installation, the anchor plate has to be covered with a round cap.